- Metallic glasses (MG) have an amorphous atomic structure and exhibit several exceptional properties such as high strength, hardness associated with high elastic strain limit and elastic energy storage. But MGs are also prone to brittle fracture, making them difficult to use as monolithic structural components and might better be used as a reinforcement phase in hybrid composites such as metal matrix composites (MMC). The failure behavior of composites depends on the structure of the reinforcement phase. In this work, the failure behavior of an interpenetrating MMC reinforced with a MG (Ni60Nb20Ta20) lattice-like preform and AlSi12-matrix was investigated by in-situ compression tests under scanning electron microscopy to get a better understanding of the influence of the lattice-like preform and mechanical interference between both phases. Additionally, microstructure analysis by scanning transmission electron microscopy and energy dispersive X-ray measurements were carried out to gainMetallic glasses (MG) have an amorphous atomic structure and exhibit several exceptional properties such as high strength, hardness associated with high elastic strain limit and elastic energy storage. But MGs are also prone to brittle fracture, making them difficult to use as monolithic structural components and might better be used as a reinforcement phase in hybrid composites such as metal matrix composites (MMC). The failure behavior of composites depends on the structure of the reinforcement phase. In this work, the failure behavior of an interpenetrating MMC reinforced with a MG (Ni60Nb20Ta20) lattice-like preform and AlSi12-matrix was investigated by in-situ compression tests under scanning electron microscopy to get a better understanding of the influence of the lattice-like preform and mechanical interference between both phases. Additionally, microstructure analysis by scanning transmission electron microscopy and energy dispersive X-ray measurements were carried out to gain insight into the chemical composition of the interfaces. The failure behavior in manufacturing direction of the MMC is dominated by shear stress whereas transversely to manufacturing direction by normal stress and exhibits therefore an anisotropic failure behavior. Investigations of the interfaces show more of a mechanical than chemical bonding but in general a good interfacial bonding was confirmed.…